TEAC CD-BT1
Owner's Manual

Using the tuner
�e �������s built�in tuner has two modes� an automatic mode� where the pitch of the incoming signal is detected and displayed automatically� and a manual mode� where you set the �target� and tune to it� �ress the MENU key until the display shows TUNER, and then press ENTER� �une the string roughly so that the right note appears� and then adjust the tuning until the tuning display shows only a large center �blob�� with both the õ and � showing� �e range of the tuner is between �� and ��� which covers almost all the useful audible range� �f the tuner is in manual mode �shown as MT on the display�� use the 6 and fl keys to set the note on the display� and then tune as above�
Although you do not need to play a CD when you are tuning, the CD-BT1 must be switched on, and the BASS button must be pressed in to allow tuning of the instrument plugged into the CD-BT1.

NOTE

�hen you enter the tuner mode� any effect is automatically turned off� �f the tuner is in automatic mode �shown as AT on the display�� just play a note on your bass� �e tuner guesses the closest note and shows it on the display� �e symbols to the left and right of the larger center symbol show that the incoming note is either flat �shown by a â on the display� or sharp ��� respec� tively�

Calibrating the tuner
�sually� the � above �iddle � is tuned to ����z �in most �estern music�� �ere may be times when you need to tune to a different standard �you are playing with another instrument or to a �� which does not use the ����z tuning�� �se the tuner�s CAL �calibration menu� to set the �reference �� to a tun� ing between ����z and ����z�

18 � TASCAM CD-BT1